A trench approximately 25mm deep by 220mm wide is first dug into the area where the kerbing will go using one of our compact Bededger machines.

Next we mix the mortar, this consists of sand, cement, special reinforcing fibre, desired colour and water.

We then install the correct mould (examples at Moulds) to the extruder machine, After this we feed the freshly mixed mortar into it, it then lays the kerbing in a continuous piece.

Using special formed hand trowels the concrete kerbing is quickly smoothed into a beautiful and professional looking product.

While the concrete is still damp we will imprint it with the chosen patterns or textures (please see our kerbing page for examples) Also at this stage as a precaution we cut small control joints in discreet areas.